FORD FOCUS IPOD INSTALLATION MANUAL GUIDE
Download Free Ford Focus iPod Installation Manual Guide.pdf This section pertains to Ford Focus vehicles that do not have a factoryinstalled satellite receiver. To install the iPod Adapter you will need to access the back of the OEM radio in your vehicle. Specific instructions for removing the trim in your vehicle are included in this guide. If you are not confident that you can safely remove your interior trim to perform the installation, contact your dealer or a competent mechanic for assistance.
You should be installing you Brandmotion iPod Adapter into a Ford Focus with an OEM radio that is similar to this picture. Radio Removal Instructions: 1) Remove panel by snapping of trim cover. 5) Disconnect A/C controls 2) Remove four 7mm screws holding radio in place. 3) Remove radio from cavity 4) Disconnect radio connectors from radio and set radio aside. 6) Connect Brandmotion Vehicle Harness to vehicle using both the 16 pin and 24 pin connector (note if your vehicle does not have a 16 pin harness the unit will work as long as the radio has the female 16 pin connector on the back of the unit). The part number of the radio verifies that your particular vehicle has the 16 pin female connector on the back of the radio.
Related Posts
« ALFA ROMEO GT JTS SELESPEED MANUAL – FORD FOCUS VIA OBD II CONNECTION MANUAL »
No Comments
No comments yet.
Sorry, the comment form is closed at this time.
